Sharp XLT300H Operation Manual page 19

To stop playback:
Press the button.
To resume playback, press the ( ) button.
To interrupt playback:
Main unit operation:
Press the button.
To resume playback from the same point, press the
Remote control operation:
Press the button.
To resume playback from the same point, press the
To remove the CD:
Whilst in the stop mode, press the OPEN/CLOSE button.
Notes:
z After removing the CD, make sure to press the
button and close the CD/Cassette compartment.
z When the unit enters the stand-by mode, the opened CD/Cas-
sette compartment cover will be closed automatically.
Caution:
z Do not stop or move the CD/Cassette compartment cover
manually. It may cause malfunctions to the unit.
z Be careful not to jam your fingers in the CD/Cassette com-
partment cover.
z If the power fails whilst the compartment is open, wait until the power
is restored.
z If a disc is damaged, dirty, or loaded upside down, "NO DISC" or
"READ ERR" will appear on the display.
z Keep foreign objects out of the CD/Cassette compartment.
z Subjecting the unit to shock or vibration may cause mistracking.
z When the unit is not being used, be sure to close the CD/Cassette
compartment. If it is left open, the lens may be covered with dust and
the unit may not operate properly.
z If TV or radio interference occurs during CD operation, move the unit
away from the TV or radio.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
„ Headphones
z Before plugging in or unplugging the head-
phones, reduce the volume.
z Be sure your headphones have a 3.5 mm (1/
button again.
8") diameter plug and are between 16 ohms
and 50 ohms impedance. The recommended
impedance is 32 ohms.
button.
z Plugging in the headphones disconnects the
speakers automatically. Adjust the volume
using the VOLUME buttons.
„ Care of compact discs
OPEN/CLOSE
Compact discs are fairly resistant to damage, however mistracking
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD collec-
tion and player.
z Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.
z Keep your discs away from direct sunlight, heat, and excessive
moisture.
z Always hold the CDs by the edges. Fingerprints, dirt, or water on
the CDs can cause noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the centre, along the radius.
NO
02/1/29 e2.fm
XL-T300H
ENGLISH
YES
Correct
E-13