Automatic Ice And Water Dispenser - Frigidaire FRS26ZGGW6 User Manual

Automatic Ice and
Water Dispenser
Dispenser Selector
Press glass against dispensing arm.
Ice Maker
The ice and water dispenser on the freezer door conveniently dispenses chilled
water, crushed ice, and ice cubes. To operate dispenser, slide the knob to the
selection of your choice. Press a glass against the dispensing arm, as shown left. Be
sure to hold the glass up as far as possible to catch all cubes. To stop dispensing, pull
glass away from dispensing arm. When dispensing ice, release dispensing arm
before glass is full, but do not remove the glass until the ice has completely
dispensed.
A small heated area beneath the dispenser floor catches and evaporates small spills.
Do not pour water or excess cubes into this area, because there is no drain.
How the Water Dispenser Works
The water tank is located behind the drawers in the refrigerator compartment. As
the water is dispensed, the tank is automatically refilled. For proper operation of the
dispenser, the supply water pressure must fall between 30 psi and 120 psi.
After refrigerator is installed, and the plumbing connections are complete, the water
tank should be filled by drawing one glass of water. It may take
approximately 1-1/2 minutes after depressing dispenser arm, before water
works its way through the plumbing connections, and begins to fill this first glass.
Draw and discard 7 more glasses to be sure tank and plumbing connections are
rinsed of any impurities.
To ensure fresh-tasting water, plan to use dispenser every day. If water
dispenser has not been used for a week or more, draw and discard 7-8 glasses to
freshen tank supply.
How the Ice Dispenser Works
The ice maker and ice storage bin are located in the top left corner of the freezer
compartment. After refrigerator is installed properly and has cooled for several
hours, the ice maker can begin making ice. To begin ice production, lower the wire
signal arm to the "down" or ON position. As cubes are made, they are stored in the
storage bin. With no usage it will take approximately 2 days to fill the bin. However,
the dispenser may be used after the first batch of ice is made. Ice maker turns off
automatically when the ice storage bin is full.
Because of the new plumbing connections, the first production of ice cubes may be
discolored, or have an odd flavor. These should be discarded until cubes made are
free of discoloration and taste.
determines your ice quality. It is best to connect the ice maker to water that is not
softened. Chemicals from a malfunctioning softener can damage the ice maker. If
ice maker is connected to soft water, ensure the softener is maintained and working
p r o p e r l y .
To stop the ice maker, lift the wire signal arm until it clicks, and locks in the "up" or
OFF position.
Light
The dispenser has a light that can be turned on and off by sliding the knob to desired
position. The light also turns on automatically when ice and/or water is dispensed.
Replace light bulb with an appliance bulb of the same wattage.
Remember that water quality