Removing Handles And Doors - Frigidaire FRS26ZGGW6 User Manual

Removing Handles and
Doors
Removing handles and trim
WATER LINE NUT
I l l u s t r a t i o n 1
I l l u s t r a t i o n 2
If you need to move refrigerator through narrow doorways, follow these
steps to remove handles and/or refrigerator and freezer doors.
To Remove Handles
Full-length Trim:
1 . Using a putty knife, carefully slide corner of the blade under trim. Slide blade
down until you find trim lock. Carefully maneuver blade against trim lock from
the side, as shown. Note: Pressing down on trim lock from above will not release it.
2 . Carefully push putty knife firmly against trim lock and twist gently. Trim lock will
snap free from door. (Each trim piece will have two trim locks.)
3 . Grasp trim and pull up away from handle using a slight side-to-side motion.
4 . Remove screws attaching handle to door.
5 . Repeat these steps for each handle end. Keep screws and trim pieces.
6 . To replace handles, line up handle with screw holes, insert screws, and tighten.
Slide upper and lower trim pieces back on handle ends, and snap trim locks back
into holes on door front.
To Remove Doors
Before removing doors, be sure freezer control is turned to OFF. Remove all food
from doors and unplug refrigerator. Next, remove toe grill.
Trace around hinges with a soft lead pencil. This will make it easier to realign doors
when they are replaced. Completely remove one door before removing other door.
Freezer Door:
1 . Remove toe grill. (See Outside in "Care and Cleaning" section.)
2 . Remove wiring cover located over lower hinge of freezer door. Cover is held in
place by a single screw. (Illustration 1)
3. To disconnect wiring harness plug (connector), position yourself to be able to
place your thumbs on the flat sides of each connector piece. Bend both parts
back and forth. Then with a firm grasp, pull the two pieces apart
4 . To disconnect water line, hold water line elbow and push in on gray collar, forcing
elbow down, off from tube that runs into door.
5 . Place a strip of tape along door bottom, over lower hinge, and up the side of the
door. This will hold hinge in place when door is removed.
6 . Remove top bolt of lower hinge. Loosen, but DO NOT REMOVE, bottom bolt of
lower hinge.
7 . Remove top hinge cover by lifting back of cover and sliding forward. Remove
hinge screws from hinge bracket with a counter-clockwise motion. Note: Hinge
has minimal spring tension. Hold bracket when removing last screw. DO NOT
remove hinge bracket from door.
8 . Carefully lift door up and off loosened lower hinge bolt. (Illustration 2)
Refrigerator Door:
1 . Remove top hinge cover by lifting back of cover and sliding forward. Remove
hinge screws from hinge bracket with a counter-clockwise motion. Note: Hinge
has minimal spring tension. Hold bracket when removing last screw. DO NOT
remove hinge bracket from door.
2 . Remove top bolt of lower hinge. Loosen, but DO NOT REMOVE, bottom bolt of
lower hinge.
3 . Carefully lift door up and off loosened lower hinge bolt.
Store doors in a safe place until refrigerator is moved to desired location. Keep all
hardware for reinstallation.
To Reinstall Doors
To reinstall doors, reverse instructions used to remove doors. Note: To reinstall
water line, push elbow up, onto door tube, until collar touches tube ink mark as
shown left.
as shown.