Wps - Comtrend Corporation VR-3033 User Manual

6.11.3 WPS

Wi-Fi Protected Setup (WPS) is an industry standard that simplifies wireless security
setup for certified network devices. Every WPS certified device has both a PIN
number and a push button, located on the device or accessed through device
software. The VR-3033 has a WPS button on the device.
Devices with the WPS logo (shown here)
support WPS. If the WPS logo is not present
on your device it still may support WPS, in
this case, check the device documentation
for the phrase "Wi-Fi Protected Setup".
NOTE: WPS is only available in Open, WPA-PSK, WPA2-PSK and Mixed
WPA2/WPA-PSK network authentication modes.
modes do not use WPS so they must be configured manually.
To configure security settings with WPS, follow the procedures below. You must
choose either the Push-Button or PIN configuration method for Steps 6 and 7.
I. Setup
Step 1: Enable WPS by selecting Enabled from the drop down list box shown.
Step 2: Set the WPS AP Mode. Configured is used when the VR-3033 will assign
security settings to clients. Unconfigured is used when an external
client assigns security settings to the VR-3033.
NOTES: Your client may or may not have the ability to provide security settings to
the VR-3033. If it does not, then you must set the WPS AP mode to
Configured. Consult the device documentation to check its capabilities.
Other authentication
103