Table of Contents
Advertisement
Troubleshooting
The burner will not
light using the igniter.
Wire is shorting (sparking)
between igniter and electrode.
Burner will not
light with match
The LP gas tank valve is closed.
The LP gas tank is low or empty.
The LP gas leak.
The battery needs to be changed.
The electrode and burners are wet.
The electrode cracked or
broken — sparks at crack.
Wire loose or disconnected.
The igniter is bad.
There is no gas flow.
The LP gas tank is low or empty.
An LP gas leak.
The coupling nut and regulator are
not fully connected.
An obstruction of the gas flow.
A disengagement of
burner to valve.
Spider webs or insect nest
are in the burner/venturi tube.
The burner ports clogged
or blocked.
Make sure that the regulator is securely attached to the
LP gas tank per the "Installing the Gas Tank" section. Then
turn the LP gas tank valve to "OPEN."
Exchange, refill or replace LP gas tank.
1. Turn LP gas tank valve to "CLOSED".
2. Wait 5 minutes for gas to clear.
3. Follow "Checking for Leaks" section.
Replace the "AAA" battery
(follow assembly step for inserting battery).
Wipe the electrode and burners dry with a cloth.
Replacement part(s) may be needed contact.
Customer Care at 1-855-HD-HAMPTON.
Replacement part(s) may be needed contact.
Customer Care at 1-855-HD-HAMPTON.
Replacement part(s) may be needed contact.
Customer Care at 1-855-HD-HAMPTON.
Replacement part(s) may be needed contact.
Customer Care at 1-855-HD-HAMPTON.
Check to see if the LP gas tank is empty. If the tank is empty,
exchange, re ll or replace it. If the tank is not empty, refer to
"There is a sudden drop in gas ow, or the ame height is
reduced" below. ,
Exchange, refill or replace LP gas tank.
1. Turn LP gas tank valve to "CLOSED".
2. Wait 5 minutes for gas to clear.
3. Follow "Checking for Leaks" section.
Turn the coupling nut about one-half to three-quarters
additional turn until solid stop. Tighten by hand only —
do NOT use tools.
1. Clear the burner/venturi tube.
2. Check for bent or kinked hose.
Re-engage the burner and valve.
Clean the burner/venturi tube.
Clean the burner ports.
27
Advertisement
Table of Contents
