Toshiba V Series User Manual page 46

Chapter 1 Module
1
34
(3) Offset calibration data
Offset calibration data contains the setting after user calibration.
15 14 13 12 11
Mode
± 5 V, ± 10 V(Biploar)
0 to 5 V, 0 to 10 V, 1 to 5 V,
0 to 20 mA, 4 to 20 mA(Unipolar)
Note 1: When the value after user calibration is negative in the case of unipolar, the
analog input data will be zero.
Note 2: Initial value is the value for No setting in the above table.
(4) Gain correction data
Gain calibration contains the setting after user calibration.
15 14 13 12 11
Mode
± 5 V, ± 10 V(Biploar)
0 to 5 V, 0 to 10 V, 1 to 5 V,
0 to 20 mA, 4 to 20 mA(Unipolar)
Note: Initial value is the value for No setting in the above table.
Supplementary
• Note that the calibration data is initialized if the output mode is changed with jumpers after
setting parameters.
• The calibration data is initialized at shipment.
10 9 8 7 6
User offset
min
-200
-400
10 9 8 7 6
User gain
min
1800
3600
5 4 3 2 1
Valid range
Not set max
0 200
0 400
5 4 3 2 1
Valid range
Not set max
2000 2200
4000 4400
model 3000 Analog module User's Manual
0
0