Handle (Optional) - Jenn-Air JUBFL242HX Use And Care Manual And Installation Instructions

GLASS DOOR OVERLAY PANEL — PREPARATION
Create the custom overlay panel using the dimensions
shown in the illustration "Glass door overlay panel and
hinge routing dimensions". Route shaded areas to a 1/2"
(12 mm) depth as shown.
IMPORTANT: The following graphic shows a custom
panel for a door with the hinges installed on the right-
hand side. If your beverage center has the hinges
installed on the left-hand side, rotate the custom frame
180° so the hinge markings will be on the left.
1/4"
(7 mm)
1/8"
(3 mm) (125 mm)
1/2"
(12 mm)
Glass door overlay panel and hinge routing dimensions
2"
(53 mm)
415/16"
305/8"
(77.75 cm)
171/16"
(43.3 cm)
2113/16"
(55.4 cm)

HANDLE (OPTIONAL)

Custom handles are typically attached to the custom
overlay door panel only.
Refer instructions received with JennAir
NOIR handle kits to install these handles on custom
TM
wood panels.
Custom handle needs to be installed on the door panel
with countersunk holes and installed before the custom
overlay door panel has been installed on the beverage
center door.
233/4"
(60.3 cm)
RISE and
® TM
7