Reverse Door Swing (Optional) - Jenn-Air JUB24FRACX Use & Care Manual

The door hinges are factory installed on the right-hand side. If you
want the door to open from the opposite direction, you must
reverse the door.
IMPORTANT: To avoid strain on the hinges, it is recommended
that you use two people to remove the door.
Tools Needed: Phillips screwdriver and a ¹⁄₈" hex key wrench.
Remove the Door
1. Unplug or disconnect power and remove any items that might
be stored inside.
2. Open the door completely to 90°.
90˚
3. While one person supports the door, remove the screws
attaching both the top and bottom hinges to the cabinet.
NOTE: After the screws are removed and the door is pulled
away from the cabinet, a plastic spacer, located behind the
bottom hinge, will become free. Set the spacer aside. You will
need this spacer when you reinstall the door.
Reverse Door Swing
A
(optional)
4. Remove the door from the cabinet and gently lay it on a flat
surface to avoid damaging the covers attached to the top and
bottom hinges.
A
A. Hinge cover
B. Custom overlay door frame
5. Reinstall the screws into the holes remaining after the hinges
are removed from the cabinet.
6. If a wooden overlay panel has been previously installed,
remove the panel. See "Install Custom Overlay Frame."
Reverse the Door
1. Remove the screws attaching the black, metal L-beams to the
top and bottom of the door.
2. Remove the screw attaching the metal light switch plate to the
center of the bottom L-beam. Remove the light switch plate.
NOTE: The light switch plate is attached with both a screw
and adhesive tape. It may require some force to remove it
from the L-beam.
A
B
A. Light switch plate
B. Bottom L-beam
C. Top L-beam
3. Remove the two metal, L-beams from the door noting which
L-beam was on the top and which was on the bottom.
4. Move the L-beams to the opposite ends of the door with the
hinges now on the left-hand side (as you are facing the front of
the door).
B
A
A. Bottom L-beam
B. Top L-beam
A
B
C
A
7