Table of Contents
Advertisement
56
VIDEO Plus+
Timer Programming
You can programme this unit to timer-record as many as
8 programmes.
With the VIDEO Plus+ system, timer programming is greatly
simplified because each TV programme has a corresponding
code number which your unit is able to recognize.
You can use the remote control to enter the PlusCode number.
Before performing the VIDEO Plus+ Timer
Programming:
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.
● Make sure that the unit's built-in clock is set properly.
®
A
Load a disc.
A Press x to open the disc tray.
B Place a recordable disc on the disc tray.
● For details, refer to "Placing a Disc" (
C Press x to close the disc tray.
B
Access the VIDEO Plus+ screen.
Press VIDEO Plus+.
C
Enter the PlusCode number.
Press the number keys to
enter the PlusCode number
of a programme you wish to
record, then press ENTER.
● If you have made a mistake,
press & and input the correct
number before you press
ENTER.
● To clear all entered numbers at a time, press 8.
● If the number you entered is invalid, "PLUSCODE NO. ERROR
CONFIRM PLUSCODE NO. THEN RETRY" appears on the TV
screen. Input a valid PlusCode number.
● If "GUIDE PROGRAMME IS NOT SET SELECT CHANNEL
YOU WANT TO RECORD" appears on the TV screen, set
Guide Program Numbers (
● When "PROGRAMME FULL DELETE UNWANTED TIMER
PROGRAMME" appears on the TV screen, you need to cancel
some of the reserved programmes. (
D
Check the programme data.
The PlusCode number you entered and the matching
timer-recording information are displayed on the TV
screen. Check if they are correct.
● To cancel this setting, press VIDEO Plus+ or RETURN.
IMPORTANT:
Make sure the channel position number you wish to record is
displayed; if not, see "VIDEO Plus+
page 97 and set the Guide Program number correctly.
TIMER RECORDING
pg. 10).
pg. 97) manually.
pg. 63)
System Setup" on
®
Advertisement
Table of Contents
