Quick Start Function
Quick Start Function
When you close the LCD panel with the camcorder on, the camcorder enters the standby mode. In
standby mode the camcorder consumes only about 1/3 the power used when recording, saving
energy when you are using a battery pack. Additionally, when you open the LCD panel or pull out the
viewfinder, the camcorder is ready to start recording in approximately 1 second*, allowing you to
record the subject right away.
* The actual time required varies depending on the shooting conditions.
48
Operating modes:
1 With the camcorder on and in a recording mode, close the LCD panel.
• A beep will sound and the green ON/OFF (CHG) indicator will change to orange to indicate the
camcorder entered standby mode. In addition, the tally lamp will flash twice approximately every
3 seconds.
• When using only the viewfinder (with the LCD panel closed), you can return the viewfinder to its
retracted position to set the camcorder in standby mode.
2 When you wish to resume recording, open the LCD panel.
• The ON/OFF (CHG) indicator turns back green and the camcorder is ready to record.
• You can also pull out the viewfinder to start recording with the LCD panel closed.
IMPORTANT
• Do not disconnect the power source during standby mode (while the ON/OFF (CHG) indicator is lit
in orange).
NOTES
• The camcorder will not enter standby mode while the ACCESS indicator is on or flashing, while a
menu is being displayed or while using the viewfinder. The camcorder may also not enter standby
mode when the battery charge is too low. Check that the ON/OFF (CHG) indicator changes to
orange.
• About standby mode and auto power off:
- The camcorder will power off automatically if left in standby mode for 10 minutes. Press x
to turn on the camcorder.
- You can select the length of time until shut-off or turn off the Quick Start function altogether with
the 6
- The usual 5-minute auto power off setting of [Power Saving Mode] is not applicable while the
camcorder is in standby mode.
• Changing the position of the mode switch while the camcorder is in standby mode will reactivate the
camcorder in the operating mode selected.
[Power Saving Mode]
[Quick Start (Standby)] setting.