Canon XA10 User Manual page 153

[Audio Output CH]:
Selects the channels from which audio will be output.
[ CH1/CH2]: Audio from CH1 is output from the left audio channel and audio from CH2 is output
from the right audio channel.
[ CH1/CH1]: Audio from CH1 is output from both the left and right audio channels.
[ CH2/CH2]: Audio from CH2 is output from both the left and right audio channels.
[ All/All]: Audio from CH1 and CH2 is mixed and output from both the left and right audio
channels.
• [Audio Output CH] cannot be set for signals output from the HDMI terminal.
[Wireless Remote Control]:
[Tally Lamp]:
Activates the tally lamp when the camcorder is recording, the camcorder is in standby
mode, the wireless controller is being operated, the battery level is low or the memory is full. When set
to [B Off], the tally lamp will not turn on in these cases.
[POWERED IS Button]:
Determines the operation mode of the POWERED IS button.
[x Press and Hold]: Powered IS will be activated while you hold the button pressed down.
[y Toggle On/Off]: Each press of the button will turn the Powered IS function on and off.
[Set WB Priority]:
You can press an assignable button set to [m WB Priority] to switch between the
current white balance and the white balance setting selected for [Set WB Priority].
[Focus Ring Direction]:
Changes the direction the focus ring needs to be turned.
[Focus Ring Response]:
Selects the sensitivity of the response when operating the focus ring.
[Focus Preset Speed]:
Determines the speed at which the focus changes to the preset position.
[Autostart Decoration]: When set to [
stow the LCD panel with the LCD screen facing out.
[Power Saving Mode]:
Controls the camcorder's automatic power off settings.
[Auto Power Off]: In order to save power when the camcorder is powered by a battery pack, it will
automatically shut off if left without any operation for 5 minutes.
• Approximately 30 seconds before the camcorder shuts off, [Auto Power Off] will appear.
• In standby mode, the camcorder will shut off after the time selected for the [Quick Start (Standby)]
setting.
[Quick Start (Standby)]: Select whether to activate the Quick Start function (0 48) when you close the
LCD panel in a recording mode and the length of time after which the camcorder will end the standby
mode and shut off automatically.
• You can set Quick Start to [Off], for example, if the camcorder is set on a fixed position and you
want to keep recording video with the LCD panel closed in order to conserve the battery's power.
[Battery Info]:
Displays a screen where you can verify the battery charge (as a percentage) and the
remaining recording time (
Allows the camcorder to be operated with the wireless controller.
On], the decoration screen will open automatically when you
A
, mode) or playback time (
Appendix: Menu Options Lists
, mode).
153