Hardware Installation
2.10.5 Printer
Plug in the printer bracket connector onto
the onboard parallel connector marked
CN7 on the board. Refer to the figure.
The printer port on the bracket accepts
the printer cable.
2.10.6 IDE Devices
Primary IDE Connector
HDD 1
The primary IDE connector marked
CN8 on the system board supports two
IDE devices - one IDE hard disk and
one additional IDE device.
Connect
your IDE HDD into the master port of
the primary IDE cable.
Plug in the
slave port into another IDE device, if
HDD 2
any.
2-19