Model HD9155 Production Afterburner Manual
6.4.18. WIN DLO (18) Data Logging Output
DLO: NOT ENABLED
DLO:5 22:28:06:04@24 22:29:00:00
DLO Type Identifier
5
22:28:06:04 Video timecode value
Video timecode counting rate
@24
22:29:00:00 Audio timecode value
6.4.19. WIN GPI (19) GPI input frame number
GPI:12:59:59:23
Video timecode of frame number where GPI input is detected going from off to on
6.4.20. WIN PRESET STS (20) Preset status
USER CONFIG WRITE PENDING-20
Displays the above message and timer countdown until non-volatile settings are saved
6.4.21. WIN OP1 STS (21) Output 1 - Parallel Connector Pin 9 status
OP1H L22:00:00:22 H23:59:59:23
current status of output pin H/L depends on function programmed for this output
H
L22:00:00:22 Output Video Timecode at which output pin last went low
H23:59:59:23 Output Video Timecode at which output pin last went high
6.4.22. WIN OP2 STS (22) Output 2 - Parallel Connector Pin 5 status
OP2H L22:00:00:22 H23:59:59:23
current status of output pin H/L depends on function programmed for this output
H
L22:00:00:22 Output Video Timecode at which output pin last went low
H23:59:59:23 Output Video Timecode at which output pin last went high
Page 6-10
Revision 1.3
TECHNICAL DESCRIPTION