Step 3 - Uploading The New Firmware; Step 4 - Completing The Upgrade; Table 2: Typical File Names - evertz HD9155 Series Instruction Manual

6.3.3. Step 3 – Uploading the new firmware
7. Upload the "*.bin" file supplied using the X-Modem transfer protocol of your terminal program. If you
do not start the upload within 10 minutes the unit's Boot code will time out. You can restart the
upgrade process by power cycling the unit. The following table indicates the file names of various
firmware for these units.
Example of File name
DE9150_xxxx.BIN
HQ9150_xxxx.BIN
7720AD-HD_xxxx.BIN
7720AD-A4-HD_xxxx.BIN
(xxxx will be the build number of the software).
8. The boot code will indicate whether the operation was successful upon completion of the upload.
For Example:
UPLOAD OKAY
7700PB COLD BOOT> |
9. The following is a list of possible reasons for a failed upload:
•
If you get the message "transfer cancelled by remote" you must restart the terminal program and
load the bin file, then remove and install the module again.
•
The supplied "*.bin" file is corrupt.
•
Wrong file specified to be uploaded.
•
Wrong file transfer protocol used – make sure you specify Xmodem, not Xmodem 1K.
•
The PCs' RS-232 communications port can't handle a port speed of 57600.
•
Noise induced into the Serial Upgrade cable.
6.3.4. Step 4 – Completing the Upgrade
10. Type the word "boot", without quotes, and hit the <ENTER> key once or power cycle the unit. The unit
should now reboot.
11. You can now close the terminal program and disconnect the RS-232 serial cable from the PC.
TECHNICAL DESCRIPTION
Model HD9155 Production Afterburner Manual
Binary File for downconverter module in HD9155, HD9155-AES,
HD9155-AUD
Binary File for downconverter module in HD9155Q, HD9155Q-AUD
Binary File for Audio De-embedder module in HD9155-AES
Binary File for Audio De-embedder module in HD9155-AUD,
HD9155Q-AUD

Table 2: Typical File names

Revision 1.3
Description
Page 6-5