BLINDS2GO Roman Installation Manual

Fitting the brackets

Use the single hole in the top of the bracket to fix to

the lintel (the 'ceiling' of the recess).

5cm

The brackets offer two methods of installation:

Top-Fixing

We've made a handy video version of this fitting guide, just

click the play button to view it.

If you prefer to print the instructions or simply to follow

step-by-step, just keep reading.

Use two screws through the back plate to mount

onto a facing surface (a wall or window frame)

Note that the position of the outermost brackets should be at

5cm

least 5cm away from the ends of the rail, with any other

brackets evenly distributed across the width.

For safety reasons, always ensure that the top of

the blind is installed at least 150cm (1500mm)

from the floor.

Installation Guide

Roman Blinds

Face-Fixing

Table of Contents

Do you have a question about the Roman and is the answer not in the manual?

Page 1 Installation Guide Roman Blinds We’ve made a handy video version of this fitting guide, just click the play button to view it. If you prefer to print the instructions or simply to follow step-by-step, just keep reading. Fitting the brackets...
Page 2 Installation Guide Roman Blinds Fitting the blind Situate the front lip Push the back of the of the headrail into headrail upwards to front lock it into the back bracket. of the bracket. To release the blind from the brackets at any point after installing, push firmly against the blind’s headrail to disengage it from the front of the bracket.
Page 3 Installation Guide Roman Blinds Operating the blind Pull down on the front part of the chain to lower the blind, and pull down on the rear part of the chain to raise the blind. Lower Raise Top Tip If you find at any point that the blind has fallen to one side, the likelihood is that this has been caused by a simple mix-up with the controls, in that they may have been pulled the wrong way to either raise or lower, which can cause the cords to roll up unevenly.

Roman deluxe