Shoprider Torino S-778XLSBN User Manual page 17

Continued.....
Sleep Mode
Your scooter has a digital battery status indicator, which displays the current
charge status of the batteries in your scooter.
The circuitry also detects changes in power draw from the batteries.
If you scooter is left switched on without use for about five minutes the
electronics will go into 'sleep' mode to conserve power. You will see one bar on
the battery status indicator oscillate from side to side. Simply switching the
scooter off and back on will enable the scooter to operate as normal.
Constant Speed Use
As the circuitry senses changes in power draw it is possible that on journeys
where your speed is constant for an extended period of time that you will see
the single bar oscillate even though the scooter is in motion. This is due to the
prolonged period of no change in power draw.
This is perfectly normal and by simply adjusting your speed for a moment will
change the battery status indicator back to normal.
Driving in Pedestrian Areas
When using the scooter in pedestrian areas always lower your maximum speed
to that of the pedestrians around you. Remember the stopping distance of your
scooter and always allow enough space to stop safely to avoid collisions with
pedestrians or other objects.
Emergency Procedures
Should your scooter behave erratically or become unresponsive whilst driving,
release the wig-wag lever so it may return to it's neutral position and switch off
the power at the key / switch. These procedures will stop the scooter and
activate the braking system, preventing any further uncontrolled manoeuvres.
Note: Switching the power off at the key / switch can cause the scooter to stop
abruptly and should only be used to stop the scooter during an emergency
16