Table of Contents
Advertisement
Cyrillic character table (
z
1
2
Error messages
Display message
Base no power
or
No link.
Reconnect
AC adaptor.
Check Phone Line
Error
Memory Full
Use rechargeable
battery.
You must first
subscribe
to Caller ID.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit's
AC adaptor and turn off the handset, then reconnect the base unit's AC adaptor and turn on the
handset.
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
TG680xE_(en)_0917_ver013.pdf 37
TG680xE_(en)_0917_ver013.pdf 37
)
3
4
5
6
Cause/solution
R Confirm the base unit's AC adaptor is connected to the unit
and the power outlet correctly.
R The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset's registration may have been cancelled.
Re-register the handset (page 41).
R The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 10).
R Recording was too short. Try again.
R The phonebook memory is full. Erase unwanted entries
(page 19).
R The call block list memory is full. Erase unwanted entries
(page 26).
R A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 4, 7.
R You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Useful Information
7
8
9
17/9/2015 3:49:11 PM
17/9/2015 3:49:11 PM
y
37
Advertisement
Table of Contents
