Dhw Set Point Change Mode - Laars FT Series User Manual

The FT Series Floor Standing, Combination Boiler

DHW Set Point Change Mode

The display shows the following information
when changing water heating temperature set
points.
Changing between Celsius and Fahrenheit
When the button D
than 5 seconds), temperature unit will toggle
between °C and °F.
Indicate
Current DHW set point temperature
Temperature sign Celsius or Fahrenheit letter
If display is communicating with the main controller normally, the
communication icon will be indicated.
When DHW set point range is high : from 121°F (49.5°C) to 140°F (60.0°C)
When changing DHW set point, the DHW icon will flash
* Default DHW set point is 125°F (51.5°C)
• DHW 95-120°F (35 - 49°C) LOW range (Default)
-To change LOW range, press the C Button. The DHW icon and current DHW LOW will flash (a flashing
value means it can be changed).
-Turn dial E clockwise to increase and counterclockwise to decrease until desired temperature is reached.
-Press dial E to save set point changes.
• DHW 121 - 140°F (49.5 - 60°C) HIGH range
-To change HIGH range, press and HOLD the C button for more than 5 seconds. The DHW icon and
current DHW HIGH will flash (a flashing value means it can be changed).
-Turn dial E clockwise to increase and counterclockwise to decrease until desired temperature is reached.
-Press dial E to save set point changes and to Exit.
Scalding may occur within 5 seconds at a setting of 140°F (60°C). Water temperatures
over 125°F can cause severe burns, or death from scalding. Children, disabled,
and elderly are at highest risk of being scalded. Read all instructions before setting
temperature at appliance. Feel water before bathing or showering.
is pressed (for more
DANGER
57page
B
E
A
B
E
A
B
E
A
B
E
Example
A
120°F
°C or °F
H . 140°F
S24
Page 8
C
D
C
D
C
D
C
D