FEATURES AND OPERATION
Hand & Foot Control — Memory Programming & Special Functions
— Two programmable positions for storing commonly use table positions.
To Program:
Move table to desired position for memory storage.
1
Press and hold (approximately 3 seconds) desired memory position button (M1 or M2) in which table position is to be
2
stored. An audible double beep should be heard indicating table position has been programmed.
To use memory function, press and hold the memory button (M1 or M2) for 1 second. Table will return to programmed
3
position.
Holding the memory button (M1 or M2) for 3 seconds when performing step 3 will cause the memory button to re-program
to the current position of the table.
— Stops table movement when any impulse movements (HOME, Memory Function M1 or M2) are being used.
Pressing any button on the hand or foot control will cancel table movement.
Simultaneous movement
›
Press any combination of buttons for simultaneous movement of multiple functions
Simultaneous Movement
(shown as an example)
Memory Positions
Stop Control
8