OREC SF600 Instruction Manual page 8

T
HROTTLE LEVER
Push the lever (Figure 5) completely backward to operate the engine,
when engine at maximum speed. Push the throttle lever forward to
decrease engine speed, to idle speed.
L L
OCK DIFF EVER
Push the lever forward (Figure 6) when a wheel is slipping in deep or
wet ground, it makes the two wheels driven together. It is better to
engage the diff lock when the wheels are turning slowly to avoid
damage to the transmission. When a wheel
to engage the diff lock at low speed. Do not engage the diff lock on hard
surface like concrete or macadam or when turning.
H
EIGHT CONTROL
Depth of work is adjustable with the tooth (1, Figure 7). When the stand is low,
the depth of work is low. When the stand is high, the depth of work is high.
When the depth of work is important, the power needed is important and
you can hit stones and cause damage to the machine.
Resistance rod
For the hard soil. Pull up the resistance rod(2, Figure7) and use the up-cut
rotary position. (Figure 4 position B).
For the soft soil. Stick the rod (2, Figure7) in the soil deeply and use the down-
cut rotary(Figure 4 position A).
Engine controls
The machine is delivered with a specific manual. Read and understand this
manual before use or maintain the engine.
F C
UEL COCK AND HOKE LEVER
Choke lever (A, Figure 8)
Push the lever completely forward to close the choke to start engine cold,
when engine has start release it.
Fuel cock (B, Figure 8)
The fuel cock have to close when machine not use. Fuel cock is closed
pushed forward, and open rearward .
E
NGINE SWITCH
• This switch allowed to start or stop the engine (Figure 9).
• When the switch is on "stop" the engine is stopped and cannot be started.
Put the switch on "stop" position to stop the engine or to avoid starting.
• Place the switch to the "on" position to allowed the engine to start.
OREC SF600/600D
is slipping, reduce the throttle
WARNING
8
Figure 5
Figure 6
1
Figure 7
Figure 8
Figure 9