Maintenance Operations To Be Carried Out By The User - OREC SF600 Instruction Manual

MAINTENANCE OPERATIONS TO BE CARRIED OUT BY THE USER

BEFORE perform any maintenance operation on the machine, cut off the engine, and remove the spark wire from
the sparking plug
If maintenance operation is not realized, damages can occur to the machine and personal injuries to the user and/or
spectators. These damages and injuries will not be covered by the warranty.
• Daily maintenance will be performed by the user.
• Maintenance operations for first 20 hours, 100 and 300 should be realized by the dealer.
• Ask your dealer to check the machine if you meet some problems.
D ,
AILY MAINTENANCE BEFORE START WORK
Transmission oil level : check by the plug (1 Figure 13). Oil level should appear
in the hole. Check only engine stopped since ten minutes on a flat level surface.
• Use only good quality gear oil "SAE 90" or "API GL-5". Oil quantity : 3.00L
Check that there is no leaks
•
Transmission oil replacement frequency
First replacement :
After 20 hours of operation
Fuel
Check tank level is full before start to work. Check that tank plug is fully closed, and check for leaks. Use only a good
quality unleaded gasoline.
Check fuel tank is closed, wipe spillages fuel before start the machine.
Check there is no fire, electric sparks, and cigarettes near the machine
when refueling.
Clean for flammable materials
Clean the machine from flammable materials, grass, woods which can be burnt on hot surfaces of the machine, especially
around the engine and the exhaust silencer.
Tires (Figure 14)
Check tires are not cut, cracked or worn.
Check tires pressure : 1,2 bar.
Safety stickers
Check safety stickers are sticked at their place.
Replace them if they are worn and damage.
State of the working tool blade(SF600)(figure 15-1)
Blades can cut hands or fingers; always wear protective gloves when
Check that rotary blades are in good condition, change worn or damage
•
blade if the blade is worn more than (20 mm) the point B figure 15-1,
comparing to a new blade (A, figure15-1).
• Changing the blade : Unscrew the to bolts and nuts of the blade on the
shaft.
OREC SF600/600D
Later replacement:
Each 100 hours or Every year
whichever comes first.
DANGER
CAUTION
holding blades.
DANGER
12
Figure 13
TIRES PRESSURE
OK
Too High
Figure 14
figure 15-1
Too Low