Controls - OREC SF600 Instruction Manual

C
LUTCH LEVER
When the lever (1, Figure 3) is pushed down, the machine is
going to go forward or reverse. When the lever is released, the
machine stops.
Following the position of the gear lever, (2, Figure 3), the
rotative tools is clutched in the same time as the wheels. When
the lever is released, the machine and the tool stops.
G (SF600)(F
EAR BOX LEVER
This lever allowed to select 2 forward travel speed, the reverse speed
and two rotations of the tool.
A : Forward speed. The machine is going forward and the tools is
rotating at the same rotation that the wheels.
B : Forward speed. The machine is going forward and the tools is
rotating at the opposite rotation that the wheels.
C : Reverse speed. The machine is going on reverse and the tools is
not rotating.
D : Neutral. Nothing is engaged the wheels and the rotating tools are
stopped.
E : 1st Forward speed. The machine is going forward and the tools is
not rotating.
F : Neutral. Nothing is engaged the wheels and the rotating tools are
stopped.
G : 2nd Forward speed. The machine is going forward fast and the
tools is not rotating.
G (SF600D)(F
EAR BOX LEVER
This lever allows to select 2 forward travel speed, the reverse
speed
A : Working. The machine is going forward and the tools is
rotating.
B : Reverse speed. The machine is going on reverse.
C : 1 Forward speed. The machine is going forward.
st
D : 2st Forward speed. The machine is going forward.
*Neutral. Nothing is engaged on the wheels and the rotating
tools are stopped.
Release the travel lever to change of speed. When the speed is engaged, open the throttle slowly.
Take many care when travelling on reverse to not stumble on bumps, holes or debris on the ground.
OREC SF600/600D

CONTROLS

4-1)
IGURE
4-2)
IGURE
A
WARNING
DANGER
7
Figure 3
Figure 4-1
D
B
C
Figure 4-2