Table of Contents
Advertisement
.Working on a soft ground(SF600D)(Figure 12-2)
•
Start the rototiller.
•
Stick the resistance rod in the soil deeply.
•
Adjust deep of work as required.
•
Push and maintain the travel lever.
•
To stop working, release the travel lever.
The better speed depends on the hardness of the ground and the depth of
work.
Soft ground will be worked at high speed and a hard ground will be worked at
low speed.
Working on a hard ground(SF600D)(Figure 12-2)
•
Start the rototiller.
•
Pull up the resistance rod and work twice or three times.
•
Adjust deep of work as required.
•
Push and maintain the travel lever.
•
To stop working, release the travel lever.
If it is difficult to work on all the depth selected, select a less deep height and
start again. When you have finish the job with this depth, select a depth more deeper and perform the job again .
Check that nobody is around the machine especially around the area where objects can be thrown by the rototiller.
Stop working if the machine hit something, allow the machine to cool and clean from dust and debris. Check or ask
Clean the mud inside the shield around the tool. Mud and debris makes the transmission override and can damage
H
OW TO STOP THE MACHINE
•
Release the travel lever, place the transmission lever in neutral position, return to the throttle lever idle engine speed
position.
•
Turn the engine switch to stop.
•
Close the fuel cock.
Remove the spark plug.
•
S
TORING THE MACHINE
•
Drain the carburettor by closing the fuel cock when the engine is running.
•
When the engine is getting cold, drain the fuel tank by unplug the full tube from the carburettor. Open the fuel cock to
allowed the fuel to be drained in an appropriate tank.
•
Clean the machine from dust, mud and debris. Check or ask to your dealer to check if the machine is damaged. Clean
the machine with water and dry it with air under pressure.
•
Perform the normal maintenance of the machine according to maintenance chart. Store the machine in a dry protected
area. Remove sparking ignition wire from the sparking plug.
•
Remove rust and paint the metal.
•
Store the machine in a dry protected area.
*T
RANSPORTATION
disconnect the spark plug .
close the fuel cock.
Fix the machine with rope securely.
OREC SF600/600D
Never start the machine if a lever is not in neutral position.
to your dealer to check if the machine is damage.
Do not work on slope more than 15°.
the engine and the transmission.
Always store the machine on a flat, hard and level surface.
Gasoline is highly flammable:
- Store the fuel on tanks designed for this use.
- Drain the gasoline in a fully ventilated workshop or outside
- Do not smoke or make sparks during this operation.
WARNING
WARNING
CAUTION
11
Figure 12-2
Advertisement
Table of Contents
