TMG -SP75 Product Manual page 13

TO ADD OIL:
The hydraulic cylinder assembly contains hydraulic fluid that must be kept at approximately
80% full at all times for proper operation. To check the oil level and to fill remove oil filler
Plug
1. Fully retract the hydraulic ram.
2. Unscrew the oil plug.
3.Fill the oil case.
KEEP DIRT AND OTHER MATERIAL
CLEAR WHEN POURING.
W W W . T M G I N D U S T R I A L . C O M
33
P 1 3 / 2 0
4.Screw the oil plug.
33
5. Perform the Air Purge Procedure.
Discharge air procedure:
After the oil is added, turn tight the release valve,
manually or use air pump to push the piston out 3"~4",
loose the release valve, retract the piston, follow the
same procedure for 2 to 3 times, to make sure the oil is
filled completely without air inside
T o l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9