Fuse Locations; Battery Maintenance - Briggs & Stratton Snapper Pro S800X Series Operator's Manual

Regular Maintenance

Fuse Locations

The fuse blocks are located on the side of the instrument
control panel installed in the right hand fuel tank. Refer to
Figure 51 for the location and amperage of the fuses used in
this machine.
A. Charge Circuit: 20 amp fuse
B. Actuator: 30 amp fuse
C. Accessory: 20 amp fuse
D. Auxillary: 20 amp fuse
E. Main: 40 amp fuse
F. Spare: 20 amp fuse
G. PTO Clutch: 20 amp fuse
H. Fuel Solenoid: 10 amp fuse

Battery Maintenance

NOTE: This unit is equipped with a maintenance-free BCIU1
battery.
Cleaning the Battery and Cables
WARNING
Keep open flames and sparks away from
the battery.
• Be careful when handling the battery. Avoid spilling
electrolyte. Keep flames and sparks away from the
battery.
• When removing or installing battery cables, disconnect
the negative cable FIRST and reconnect it LAST. If not
done in this order, the positive terminal can be shorted
to the frame by a tool.
1. Disconnect the cables from the battery, negative (black)
cable first (B, Figure 52).
2. Clean the battery terminals and cable ends with a wire
brush until shiny.
3. Reinstall the battery and reattach the battery cables,
positive (red) cable first (A).
4. Coat the cable ends and battery terminals with petroleum
jelly or non-conducting grease.
44 44
A
B
F
E
Figure 51. Fuse Location Decal
A. Charge Circuit
B. Actuator
C. Accessory
D. Auxillary
E. Main
F. Spare
G. PTO Clutch
H. Fuel Solenoid
A
Figure 52. Battery Compartment
A. Positive Battery Cable
B. Negative Battery Cable
D
C
H
G
B
www.SnapperPro.com www.SnapperPro.com