Disconnecting Mobile Broadband; Changing Apn Settings - NTT docomo L-02C Instruction Manual

Note
• A screen to confirm PIN1 code appears according to the
setting. Enter PIN1 code after the screen appears.
• When mobile broadband is used to connect data
communication, L-02C connection software and dial up
connection are not available to use.
To "Disconnect" the mobile broadband or set auto
connection setting to "自動的に接続しない(Do not connect
automatically)" to enable to use L-02C connection
software or dial up connection.
• If select "常に自動的に接続する(Always connect
automatically)", the amount of packet transmission may go
huge due to the long time connection. Note that hefty fee
may result.
• Note that communication fees may become high when
"Always connect automatically" is set during overseas use.
Disconnecting Mobile
Broadband
a
Click or on the bottom right of task tray
b
Select "DOCOMO" Click "切断(Disconnect)"
66
Mobile Broadband
Changing APN Settings
a
Connect this terminal with a PC
• Connecting method（→P24）
b
Click or on the bottom right of task tray
c
Right click "DOCOMO" and click "プロパティ
(Properties)"
d
Click "プロパティ(Properties)" tab Set each
item
• Enter APN in "APN" field.
• Enter the specified settings by provider or network
administrator in "ユーザー名(User name)" "パスワード
(Password)" field.
• If connect to "mopera U", connection is available even if "
ユーザー名(User name)" and "パスワード(Password)" are in
blank.
• In "自動接続(Auto connection)" field, select from "常に自動的
に接続する(Always connect automatically)", "ローミング時を
除いて自動的に接続する(Connect automatically aside from
roaming )" and "自動的に接続しない(Do not connect
automatically)".
• If a PC accesses internet via LAN, check the check box of
"使用できる別のインターネット接続がない場合のみ自動接続する
(Connect automatically only when other available internet
is not being connected. )" to not connect automatically on
Windows.
e
Click "OK"