Bluetooth Phone; Bluetooth Phone Operations; Selecting A Source; Receiving A Call - JVC KS-BTA200 Instructions Manual

Bluetooth Phone Operations

• Before you use a Bluetooth device with your receiver, connect a Bluetooth device. See "Bluetooth
Connection" on page 12.
• When the sound is stopped or interrupted during the use of a Bluetooth device, try the following
remedies.
• Turn Off, then turn On the power to the receiver.
• (When sound is not yet restored,) Connect the device again. See "Connecting/Disconnecting the
device" on page 17.
• For details of the menu operations, refer to the instruction manual supplied with your receiver.
• Indications on the display (monitor) and button names vary among the receivers.
ex. SOURCE: SRC
Bluetooth Phone: Bluetooth PHONE, BT-PHONE
New Device: New device, NEW DEVICE

Selecting a source

Before you operate the Bluetooth phone function,
change the source to "Bluetooth Phone."
for Type A
Press and hold MENU to call up the
Bluetooth menu or press PHONE on the
remote controller.
for Type B/Type C/Type D
Press SOURCE repeatedly to select

"Bluetooth Phone."

7: 7 / BACK
MENU: AV MENU, AV Menu

Receiving a call

If you receive a call, "Receiving Call (and name,
phone number if acquired)" appears on the display.
Press one of the following buttons.
The source changes to Bluetooth Phone and you can
receive the incoming call.
Type A
Any key (except
0.)
Type B/Type C/Type D
Any key (except
• When another call comes in while talking, see
To end the call or reject an incoming call, press and
hold one of the above buttons.
/ATT, +/–, MAP, SRC and
/ATT and VOL +/–.)
for the Touch Panel model
You can also press the message "Receiving
Call" displayed on the touch panel to receive
a call.
"Answering a waiting call" on page 23.
Note
You can set the receiver to receive or reject the incoming call
automatically. See "Auto Answer" on page 31.
Connection/Bluetooth Phone 19