Auto Pairing; Receive A Call; Bluetooth - Mobile Phone - JVC KD-X472BT Instruction Manual

Bluetooth®
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered
in the unit even if you reset the unit. To delete the paired device, see
[DEVICE DELETE] on page 18.
• A maximum of two Bluetooth phones and one Bluetooth audio device can
be connected at any time. To connect or disconnect the registered device,
see [PHONE SELECT] or [AUDIO SELECT] in [BT MODE]. (Page 18)
However, while in BT AUDIO source, you can connect to five Bluetooth
audio devices and switch between these five devices. (Page 20)
• Some Bluetooth devices may not automatically connect to the unit after
pairing. Connect the device to the unit manually.
• When the battery of the connected Bluetooth device runs low, "Device
Name" "LOW BATTERY" appears.
• Refer to the instruction manual of the Bluetooth device for more
information.

Auto Pairing

(for KD-X472BT)
When you connect iPhone/iPod touch to the USB input terminal, pairing
request (via Bluetooth) is automatically activated if [AUTO PAIRING] is set to
[ON]. (Page 18)
Press the volume knob to pair once you have confirmed the device name.
Bluetooth — Mobile phone

Receive a call

When there is an incoming call:
• KD-X472BT:
The buttons will blink in the color you have selected in [RING COLOR].
(Page 17)
KD-X272BT:
The buttons will blink in the blinking pattern you have selected in
[RING ILLUMI]. (Page 17)
• The unit answers the call automatically if [AUTO ANSWER] is set to a selected
time. (Page 17)
During a call:
• KD-X472BT:
The buttons stop blinking and illuminate in the color you have selected in
[RING COLOR]. (Page 17)
KD-X272BT:
The buttons stop blinking.
• If you turn off the unit or detach the faceplate, Bluetooth is disconnected.
15
ENGLISH