Installation; Connection To Water Outlet - Kernau KFD 812 W User Manual

• Before contacting
of the dryer, check the information in the user manual to make sure that the electrical installation and
water outlet is suitable. If they are not, call a qualified electrician and a plumber to have the necessary
adjustments made.
• It is the customer's responsibility to prepare the dryer's installation place, as well as the electricity and
waste water installation. Before installation, check the dryer for damage. If damaged, do not have it
installed. Damaged products may endanger your health.
• Install the dryer on a stable and flat surface.
• Run the dryer in a dust-free environment where the air ventilation is good.
• The clearance between the dryer and the floor should not be reduced with objects such as carpets,
wood or tape.
• Do not block the ventilation grills found on the plinth of the tumble dryer.
• The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the
opposite side of the tumble dryer, in such a way that blocks the full opening of the tumble dryer door.
• Once the dryer has been installed, the connections must remain stable. When installing the dryer, make
sure that the rear surface is not leaning on anything (e.g. tap, socket).
• The operating temperature of the dryer is +5°C to +35°C. If operated out of this temperature range, the
performance of the dryer will be affected negatively and the product will be damaged.
• Be careful when carrying the product since it is heavy. Always wear safety gloves.
• Always install the product should be placed against a wall.
• The rear surface of the product should be placed against the wall.
• When the product is placed on a stable surface, use a water level to check if it is fully stable. If not,
adjust the feet until it becomes steady. Repeat this process every time you relocate the product.
• Do not place the dryer onto the power cable.
2.1. CONNECTION TO WATER OUTLET (WITH OPTIONAL DRAIN HOSE)
In products with a condenser unit, water accumulates in the water tank during the drying process. You must
empty the accumulated water after each drying process. Instead of periodically emptying the water tank, you
can also use the water drain hose provided with the product to directly drain the water outside.
2.1.1. CONNECTING THE WATER
DISCHARGE HOSE
• Pull and take out the end of the hose at the back
of the dryer. Do not use any tools to take out
the hose.
• Fit one end of the water discharge hose, which
is provided with the product, to the slot from
which you have removed the hose.
• Fix the other end of the water discharge hose
directly to the water outlet or sink.

2. INSTALLATION

the local Authorised Service Provider
2
EN
44
for the installation
1
3