Advertisement
PROBLEM
AIR CONDITIONER
DOES NOT OPERATE
AIR CONDITIONER
"DOES N~ COOL
OR HEAT AS IT
SHOULD"
"BURNING" ODOR
AT START OF
OPERATION
OPERATING SOUNDS
DISCHARGED AIR
CONDENSES ON
WINDOWS OR
WALLS
If
you need more help...dl, toU free:
GE
consumer information setice
POSSIBLE CAUSE AND REMEDY
Unit Power Switch behind room cabinet is set at OFF.
Unit is waiting 3 minutes for pressure to equaltie across the compressor.
Curtains, blinds or furniture blocking f~ont ~f air conditioner will restxict air flow.
Thermostat Control may not be set high enough. Slide cofitrol to a lower or higher
number. Highest setting should provide maximum cooling.
been
Room may have
Allow time for it to cool down or warm up.
. Conditioned air may be escaping through open furnace floor registers and cold air
returns.
the room.
limit the operating ranges. See page .4.
Position of the louvers will affect temperature. See page 3.
Dust accumulating on surface of heating e~ement during tmnspo~tion or storage
can cause "burning" odor at beginning Of.h?aiing o~mtion. This odor should
dissipate.
. Relay clicks may be heard when compressor or fan cycles on and off. This is normal.
Fan runs continuously when The~ostit Switch is set at FAN ONLY or Fan Cycle
Switch behind room cabinet is set at CONTINUOUS. This is normal. Otherwise, the
fan cycles on and off with the compressor or resistance heater.
Tilt louvers down slightly and keep them down until condensation disappears.
very hot or very cold when air conditioner was first turned on.
'
6
allowing outside air to enter
Advertisement
