Advertisement
1
2
3
Indicator Li@b
Lights when the
Ventilation control
VENT
is set at OPEN.
Lights when the
air conditioner is
COOL
operating in the
cooling mode.
Lights when the
air conditioner is
HEAT
operating in the
heating mode.
Lights when the
compressor does not
SERVICE
start after several
attempts or when
there is a compressor
malfunction.
Air buvers
For best heat distribution, tilt
the louvers down so the heated air
is directed across the room.
THERMOSTAT
4
5
6
7
Thermostat Control
The Thermostat Control has
numbered settings plus a FAN
ONLY position.
Slide the Thermostat Switch to
the lower numbers for cooler
temperatures, to the higher numbers
for warmer temperatures.
For fan only operation, without
the compressor or heater, slide the
Thermostat Switch all the way to
the right to the FAN ONLY position.
Whenever room air temperature
at the air conditioner falls to
approximately 40°F., the unit will
automatically come on in the
heating mode.
For best distribution of cold air,
tilt the louvers up so the cold air is
directed towards the ceiling.
A
FAN ONLY
3
ON /STOP
COOL, FEAT
LOW
Master Controls
Push the Operation Button once to
turn the air conditioner on; push
again to turn it off.
If the unit does not operate when
you push this button to start it,
check to see if the Unit Power
Switch located behind the room
cabinet is on. See page 4*
Slide the Selector Switch to COOL
for cooling, or to HEAT for
heating.
Slide the Fan Speed Switch to
LOW for cooling or heating with
low fan speed operation. Slide it to
HIGH for cooling or heating with
high fan speed operation. When
you slide the Fan Speed Switch to
switches between low. medium and
high to follow changes in room
temperature.
controls,
*Note: After setting
a 3-minute delay before the
compressor starts is normal.
For AW heating and cooling
certification, the air louvers are
tilted straight out as shown above
(30 degrees from the vertical axis).
HIGH
1
AUTO
Advertisement
