Installation; Cut-Out Dimensions - Eaton CROUSE-HINDS Series Instruction Manual

INM UC625 rev 24
8

INSTALLATION

Installation, configuration and maintenance of this annunciator must only
The UC625 is designed for panel mounting. The rear portion of the
annunciator must be protected by an enclosure that is at least IP30 and
can only be accessed using a key or tool. Access to the rear enclosure
8 .1

Cut-out dimensions

Only one cut-out is required to mount the alarm annunciator. The size of this cut-out is dependent
on the number of alarms fitted as shown in the table below
ALARM WAYS
12
16
20
24
28
32
36
40
Please note:- Cut-Out dimensions have a tolerance of plus or minus 0.5 mm.
Table 22
Unit Depth
For standard units depth = 130 mm
WARNING !
be performed by competent service personnel
WARNING !
must be limited to service personnel only.
OVERALL SIZE (H X W) mm
154 x 152
154 x 180
154 x 208
154 x 236
154 x 264
154 x 292
154 x 320
154 x 348
CUT-OUT SIZE (H X W) mm
141 x136
141 x 164
141 x192
141 x 220
141 x 248
141 x 276
141 x 304
141 x 332
21