Set Up Parameters Page - ABB Industrial enabled Analyzer 9437 Instruction Manual

7.3 Set Up Parameters Page

– – – – –
SET UP PARAMETER
– – – – –
Disp Units ug/kg
mg/kg
ug/l
mg/l
ppb
ppm
2 0 . 0
Adjust Dec. Pt
– – – – –
Display Span
760
Pressure mmHg
0
Salinity ppt
– – – – –
Temp. Units (°C)
– – – – –
SET UP OUTPUTS
7 PROGRAMMING AND ELECTRICAL CALIBRATION...
– press to advance to next parameter
or
– press to advance to Set Up Outputs Page, Section 7.4.
These two switches are used to advance to all subsequent parameters and pages. If a
parameter is changed it is automatically stored on operation of either switch.
Display Units
Select the required display units:
µg/kg, mg/kg, µg/l, mg/l, ppb, or ppm.
Select the required decimal place
e.g. XX.XX (0.20 to 10.00), XXX.X (2.0 to 100.0) or XXXX (20 to 1000).
Select the required display span:
µg/kg, µg/l and ppb
mg/kg,mg/l and ppm
Barometric Pressure Correction
Set the local barometric pressure in mm Hg (between 500 and 800).
If the local barometric pressure is unknown the default value, which is the standard sea-
level value of 760mmHg, should not be changed.
Salinity Correction
Required when monitoring sea water or other waters containing high concentrations of
dissolved salts.
Enter the appropriate value between 0 an 80 parts per thousand (ppt).
Leave at the default value of 0 ppt if correction is not required.
Temperature Units
Select either °C or °F.
Advance to Set Up Outputs Page, Section 7.4.
Minimum Range Maximum Range
0 to 20.0 0 to 100.0
0 to 20 0 to 1000
0 to 0.20 0 to 10.00
0 to 2.0 0 to 20.0
19