Table of Contents
Advertisement
To remove the backplane:
Remove all drives out of the drive bays.
1.
Refer to the "Optical disk drive bay" and "Hard drives" sections in this chapter for detailed
procedures.
Remove the top cover.
2.
Remove all cables connected to the backplane.
3.
Remove the backplane.
4.
Remove the three screws that secure the backplane to the hard drive cage.
a.
Pull the backplane up and out to release it from the hard drive cage.
b.
Figure 31 Removing the Backplane
To reinstall the backplane:
Orient the backplane so that the notches on the backplane align with the hook on the drive cage
1.
and then press the backplane down until it clicks into place.
Secure the backplane with three screws.
2.
Removal and replacement procedures 66
Advertisement
Table of Contents
