Related Manuals for Philips AC4005
Summary of Contents for Philips AC4005
- Page 1 Always there to help you Register your product and get support at www.philips.com/welcome AC4005 Question? Contact Philips User manual...
-
Page 3: Table Of Contents
Contents 1 Important Safety 2 Your air purifier Overview 3 Get started Install filters 4 Use the air purifier Understand the air quality light Switch on Set the sensitivity of the air quality sensor 6 Auto mode Select the fan speed Eco mode Set the timer Activate child lock 5 Clean your air purifier Clean the air purifier... -
Page 4: Important
If the power cord is damaged, • you must have it replaced Danger by Philips, a service center Do not let water or any other • authorized by Philips, or liquid or flammable detergent... - Page 5 Do not use the appliance • switch on the appliance. in wet surroundings or in Only use the original Philips surroundings with high ambient • filters specially intended for temperatures, such as the this appliance. Do not use any bathroom, toilet, or kitchen.
-
Page 6: Your Air Purifier
2 Your air purifier Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.Philips.com/welcome. Read this user manual carefully before you install and use the unit. Save it for future reference. -
Page 7: Get Started
3 Get started Remove all packaging material from the filters. Install filters The appliance comes with all filters fitted inside, but you have to remove the packaging of the filters before you can use the appliance. Remove all filters, unpack them, and place them Put the HEPA filter back into the appliance. -
Page 8: Use The Air Purifier
To reattach the front panel, insert the Switch on bottom hooks into the bottom of the appliance first. Then, push the panel against the body of the appliance. Plug the air purifier into the power supply. » All lights go on from left to right in cycle. -
Page 9: Auto Mode
Auto mode Note • When it is set to a higher sensitivity, the purifier starts After choosing the auto mode ( ), the cleaning the air at lower pollution levels to make the air even cleaner. Plug the purifier before adjusting the built-in air quality sensor automatically measure sensitivity of the air quality sensor. -
Page 10: Set The Timer
10 minutes, the appliance stops running while Activate child lock the lights go on. If this continues for 30 minutes, the air quality You can activate the child lock function. sensor will measure the air quality again, and automatically selects the appropraite speed Press the button to activate the child setting or back to eco mode. -
Page 11: Clean Your Air Purifier
5 Clean your air Note purifier • When the humidity level in the room is very high, it is possible that condensation develops on the air quality sensor. As a result, the air quality light may indicate that the air quality is bad even though it is good. In this case you have to clean the air quality sensor or use one of Note the manual speed settings. -
Page 12: Clean The Pre-Filter
6 Clean the pre- Pull the activated carbon filter out of the pre-filter. filter Note • The pre-filter is washable. • Clean the pre-filter when the replacement light (滤网1) flashes to ensure optimal functioning of the appliance. Wash the pre-filter under a running tap. If the pre-filter is very dirty, use a soft brush to brush away the dust. -
Page 13: Replace The Filters
7 Replace the To reattach the front panel, insert the bottom hooks into the bottom of the filters purifier first. Then, push the panel against the body of the purifier. Note • The indicator of the filter replacement (滤网2&3) indicates the activated carbon filter and HEPA filter have to be replaced. - Page 14 Switch off the purifier and unplug it. Put the pre-filter back into the purifier. Attach all hooks properly to the purifier. Place your fingers in the recesses of the To reattach the front panel, insert the side panels and gently pull the front panel towards you.
-
Page 15: Troubleshooting
8 Troubleshooting The color • The air quality sensor is dirty. of the air Clean the air quality sensor quality light (see ‘Clean the air quality always stays sensor’). This chapter summarizes the most common the same. • There is not enough ventila- problems you could encounter with the purifier. -
Page 16: Guarantee And Service
Consumer Care Center in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Consumer Care Centre in your country, go to your local Philips dealer. Order parts or accessories If you have to replace a part or want to purchase an additional part, go to your Philips dealer or visit www.philips.com/support. -
Page 17: Notices
One of Philips’ leading Business Principles is to take all necessary health and safety measures for our products, to comply with all applicable legal requirements and to stay well within the EMF standards applicable at the time of producing the products. - Page 18 Specifications are subject to change without notice © 2013 Koninklijke Philips N.V. All rights reserved. 4241 210 73021 AC4005_UM_EN_V1.0...