Using The Pm100-Btj Remote App - Projecta INTELLI JAY PM100-BTJ Manual

3.5 Using the PM100-BTJ Remote App

1. Once you have established a paired connection with your smart device, the app will take you to its home screen
where you may see a variety of system parameters.
2. It is now important to select your battery type, to ensure ideal charging and system operation. To do this, tap the
white settings cog/gear in the top right corner of the screen, then tap the down arrow under "Battery Type".
Choose your battery type from the list – AGM, GEL, LFP (lithium) or WET.
3. It is also recommended that you update your PM100-BTJ system to the latest firmware – this can be done by via
the update function in the settings menu (your system may already be up to date). Please ensure you remain in
close proximity to the system and do not disconnect power to the system or your phone during an update.
4. From the home screen, the PM100-BTJ app allows the user to remotely monitor key aspects of the power system
from the convenience of their phone or tablet, as well as remotely switch the output load's power on or off.
The following information is displayed in the app's home screen:
– House battery volts and amps (charge and discharge)
– Vehicle battery voltage
– Charging mode/status
– Power input source (grid or VCR)
– Water tank levels (when sensors connected/installed/operational)
– Load status and power button
The power button may be used to turn output load power on or off, resulting in startup or shutdown of all appliances
and lighting wired to outputs on the PM100J transformer. Note: this switch only affects output load - the app will
continue monitoring parameters and retain its Bluetooth connection to your smart device, even with the load off.
11