Kohler K-702300 Installation Manual page 9

A. Fit the foam
insert into the
groove
Bushing
10. Install the Pivot Pin
Fit a nylon washer over the long end of the pivot pin.
Insert the short end of the pivot pin into the bushing in the bottom bridge member.
11. Install the Foam Insert
Fit the door handle foam insert into the groove on one side along the length of the door handle.
Push the door handle foam insert into the other groove along the length of the door handle frame
and trim away the excess insert with a knife or scissors.
Kohler Co.
B. Push foam
insert into the
other groove
Door
Handle
Frame
Nylon
Washer
Pivot Pin
Bottom Bridge
Member
Pivot
Side
Frame
9 1032629-2-B