Advertisement
Available languages
Available languages
Pivot
Side
Frame
12. Install the Door Panel
Lift the door panel and insert the pivot hole of door side frame over the bottom pivot pin.
Align the top pivot hole of the door side frame with the top bushing and insert the long end of the
pivot pin through the bushing into pivot hole of door side frame.
For the final adjustment, confirm that the door is square to the framework opening or the bottom
door seal. Confirm that the door does not rub on the bottom bridge member.
If the door is not square or rubs, make adjustments to the framework by inserting a Phillips
screwdriver through the holes in the side panel expander jamb and turning the adjustment blocks in
as required to align the unit.
After adjustments are complete, install a #8 x 3-1/2" flathead screw into the top and bottom
adjustment holes of the expander jamb and secure the side panel in place to the wall.
13. Install the Column Caps
Install the caps to the top of each column.
Install the post caps to the posts.
1032629-2-B
Pivot Pin
Bushing
NOTE: Do not lift door
panel with pivot side
of the frame.
Pivot
Hole
Handle
Side
Top Adjustment
Hole
Post Cap
Post
10
No. 8-18 x 3-1/2"
Flathead Screw
No. 8-18 x 3-1/2"
Flathead Screw
LH Cap
Left Column
Kohler Co.
Advertisement
