STEINEL Studio 300 Operating Instructions Manual page 10

Function
After the motion detector has
been connected and fastened
to its wall mount, the system
can be switched on.
Switch-off delay
(time setting)
The desired period of oper-
ation of the light can be adjust-
ed continuously from approx.
10 sec. to a max. of 15 min.
When the adjustment screw
is at the left stop position, this
means the shortest time of
appr. 10 sec.-15 min. max.
approx. 10 sec. When the
adjustment screw is at the
Twilight setting
The desired motion detector
response threshold can be
adjusted continuously from
approx. 2 lux to 2000 lux.
When the adjustment screw
is at the left stop position, this
means daytime operation of
approx. 2000 lux.
2 - 2000 lux
When the adjustment screw
is at the right stop position,
this means twilight operation
of approx. 2 lux.
This motion detector is equip-
ped with integrated anti-daz-
zle protection and account
should be taken of the follow-
ing:
If the performance test is
conducted in daylight, the twi-
light setting screw can be set
to night operation.
14
All manuals and user guides at all-guides.com
Two setting options are
available after removing the
decorative ring.
right stop position, this means
the longest time of approx.
15 min.
(Factory setting is at min.).
The shortest time setting is
recommended when adjust-
ing the detection zone and
performing a functional test.
There must be no motion in
the detection zone within
the set illumination time and
60 seconds thereafter, other-
wise the light will remain illu-
minated.
The same procedure should
be followed for any modifica-
tion of the set twilight thresh-
old.
(Factory setting is
daytime operation.)
The adjustment screw must
be at the left stop position
when setting the detection
zone and for the functional
test in daylight.
Reach setting/adjustment
Assuming an installation sible by turning the sensor
height of 2 m, the maximum housing by ± 80°
reach of the sensor is 12 m. The shrouds can be divided
Optimum adjustment of the vertically or horizontally along
detection zone is possible ac- the grooved divisions, or cut
cording to needs. with scissors
The shrouds provided serve ving the decorative ring
to cover any desired number the shrouds are to be sus-
of lens segments and indi- pended on the upper part of
vidually reduce the reach. the sensor lens. The decora-
Fine adjustment is also pos- tive ring is subsequently to be
A B
Reach setting/examples
1
reapplied and the shrouds
. are fixed firmly in place.
A
False switching by cars and
pedestrians, etc. is therefore
ruled out, or risk areas delib-
. After remo- erately monitored.
B
,
C
C
C
15