Dear Customer, Congratulations on purchasing your new tions before attempting to install the sensor STEINEL infrared sensor and thank you for the because prolonged reliable and trouble-free confidence you have shown in us. You have operation will only be ensured if it is fitted chosen a high-quality product that has been properly.
Page 9
System components IS 3180, IS 3360, IS 345 Reset button for returning the twilight and time setting to the factory setting of 2000 Standard installation lux and 5 sec. Installation in ceiling box Fitting the decorative faceplate Basic element Lens rotates for selecting basic settings: Concealed wiring 8 m max.
Page 10
Functions The system can be put into operation once the - Manual override function (if active) is can- mains power has been connected and the unit celled is closed. Two setting options are concealed behind the decorative faceplate. The settings may be altered as often as you Pressing a programming button sets the wish.
Page 11
Manual override function If a mains switch is installed in the mains supply Important: The switch should be actuated in lead, the light is capable of the following func- rapid succession (in the 0.5 – 1 sec. range). tions in addition to the simple ON/OFF function: Sensor operation 2 x aus/an 1 x OFF/ON...
Page 12
Troubleshooting Malfunction Cause Remedy I Fuse faulty, not switched I New fuse, turn on power Sensor without power ON, break in wiring switch, check wiring with voltage tester I Short circuit I Check connections I Twilight control set to night- I Reset Sensor will not switch ON time mode during daytime...
Page 13
Low-Voltage Appliances, 73/23/EEC and the EMC Directive 89/336/EEC. Functional warranty This STEINEL product has been manufactured The warranty will only be honoured if the prod- with the utmost care, tested for proper operat- uct is sent to the appropriate Service Centre...