Table of Contents
Advertisement
J120: BUZZER_SEL Jumper
VCC5_BZ
BUZ_1
3-4: NORMAL MODE (Default)
2-3: Disable PC BEEP
1-4: Use the External Speaker
J192: System Reset Jumper
J200:FPIO_PW_SEL (33_DUAL/RUN)
J194: CMOS Clear Jumper
Normal
(Default)
Clear CMOS
Signal
Signal
COLD_RST_BTN_N
BMC_EXTRST_BTN_L
1-2: SYSTEM RESET (Default)
2-3: BMC RESET
Signal
FPIO_PW_LED_33_DUAL
FPIO_PW_LED_33_RUN
1-2 VDD_33_DUAL
2-3 VDD_33_RUN
Pin
Signal
Vbat
1-2 Normal RTC Reset (DEFAULT)
2-3 Clear RTC Registers
You can reset the CMOS settings by using this jumper. This can be
useful if you have forgotten your system/setup password, or need to
clear the system BIOS setting.
1. Power off system and disconnect power connectors from the
motherboard.
2. Remove the jumper from Pin_1 and Pin_2 (Default setting).
3. Move the jumper cap to close Pin_2 and Pin_3 for several seconds
to Clear CMOS.
4. Put jumper cap back to Pin_1 and Pin_2 (Default setting).
5. Reconnect power connectors to the motherboard and power on
system.
http://www.tyan.com
Pin
Pin
Signal
1
2
NG
4
3
BUZ_2
Pin
1
3
Pin
1
3
1
P0_Vddbt_Rtc_G
19
Pin
Signal
2
FP_RST_BTN_JP_N
Pin
Signal
2
FP_PW_LED_PW
2
GND
3
Advertisement
Table of Contents
