Table of Contents
Advertisement
3.5.1.1.1
CCD/Core/ Thread Enablement Submenu
CCD Control
Sets the number of CCDs to be used. Once this option has been used to remove
any CCDs, a POWER CYCLE is required in order for future selections to take effect.
Auto / 2 CCDs / 3 CCDs / 4 CCDs / 6 CCDs
Core control
Sets the number of Cores to be used. Once this option has been used to remove
any CCDs, a POWER CYCLE is required in order for future selections to take effect.
Auto / TWO (1 + 1) / FOUR (2 + 2) /SIX (3 + 3)
SMT Control
Can be used to disable symmetric multithreading. To re-enable SMT, a POWER
CYCLE is needed after selecting the 'Auto'option.
Disabled / Auto
104
http://www.tyan.com
Advertisement
Table of Contents
