Advertisement
Application:
Corvette 2006-2013
Powered Front License Plate Frame
Tools Needed
UNDER HOOD INSTALLATION
STEP 1.
Mount the receiver in this location using the double-backed tape pad.
STEP 2.
Run the double-strand output wire forward and down through the opening at bottom of radiator shroud. Secure wire
with tie wraps later. Run antenna wire along same path, slightly separated from power wire.
STEP 3.
Place black ground wire terminal over existing grounding stud and secure with nut provided.
UNDER BODY INSTALLATION
STEP 4.
Drive up on ramps or jack up one side. Fore safety, use a jack stand. While holding the motor, carefully pull the plate
base out and into the "show" position. Attach the long bracket to the base using the screws and nuts provided. Screws
point up as shown.
Mamotorworks
@CorvettePassion
MidAmericaMotorworks
CorvettePassion
2900 Nor th Third Street, Ef fingham, IL 62401
800.500.1500 • Worldwide: 217.540.4200 • FAX: 217.540.4800
w w w.mamotor work s.com • generalmail@mamotor work s.com
©Mid America Motorworks, Inc. All rights reserved.
INSTRUCTION SHEET
Part Number
619-800
Part Includes
License Plate
Advertisement
Table of Contents
Related Manuals for Mid America Motorworks 619-800
Summary of Contents for Mid America Motorworks 619-800
- Page 1 Mamotorworks 2900 Nor th Third Street, Ef fingham, IL 62401 @CorvettePassion 800.500.1500 • Worldwide: 217.540.4200 • FAX: 217.540.4800 w w w.mamotor work s.com • generalmail@mamotor work s.com MidAmericaMotorworks ©Mid America Motorworks, Inc. All rights reserved. CorvettePassion...
- Page 2 INSTRUCTION SHEET Page 2 000-000 Description (cont.) STEP 5. Position the base so there is a 1/16” gap in front of the spoiler. Attach the base to the “Z” brackets with screws pointing up. STEP 6. Use the existing body screw to fasten the rear bracket. STEP 7.
Need help?
Do you have a question about the 619-800 and is the answer not in the manual?
Questions and answers