Thomas & Betts STAKON COMFORT CRIMP ERG4004 Instructions For Use

ERG4004 COMFORT CRIMP
COMPRESSION TOOL WITH SHURE STAKE
For Installing AB & C-Flag Terminals 22-10 AWG and
Non-Insulated Terminals, Disconnects, and Splices 22-18, 12-10 AWG
IMPORTANT:
information in this manual before operating or servicing this tool.
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE NEST
DURING GAGING OR CRIMPING PROCEDURE.
(22-18) AB NEST
(12-10) C NEST
In the event the SHURE STAKE
1.0
1.1
For Use With AB & C Flag Terminals
AB Flag
1. Open handles fully.
2. Insert terminal into proper nest as shown in Figure 2.
AB Flag - use forward nest as indicated. Place barrel
position downward and tongue pointing rearward.
C Flag - use rear nest as indicated. Place barrel
positioned downward and tongue pointing forward.
3. Close the handles slightly to secure the terminal. Do
not deform the terminal.
4. Insert stripped wire.
5. Close handles until SHURE STAKE
cycle has been completed.
TA04529 B Page 1 of 2
TM
Read and understand all of the instructions and safety
AB C
Model No.
mechanism must be released, please see Figure 5.
®
INSTRUCTIONS FOR USE
22-10 AWG
C Flag
mechanism
®
Figure 2
®
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES.
1.2
For Use With Non-Insulated Terminals,
Disconnects, and Splices 22-18,12-10 AWG
1. Open handles fully.
2. Position terminals/splices
in proper nest as shown
in Figure 3.
22-18 - use front AB nest
12-10 - use rear C nest
Terminal barrel seam or
splice window should
face indentor.
3. Close handles slightly to secure terminal.
Do not deform terminal.
4. Insert stripped wire.
5.
Close handles until the SHURE STAKE
mechanism cycle has been completed.
6.
Repeat steps 2-5 on opposite end of
splice.
®
MECHANISM
Figure 1
12-10
C Nest
22-18
AB Nest
®
Figure 3