Placement And Mounting - Ecler essentials eAMBIT106 User Manual

The fifth switch position corresponds to low impedance operation with a
maximum power capacity of 50W. When operating at low impedance you should
always consider the limitations of the power amp when connecting several low-
impedance speakers together. Imped
low impedance operation and with long cable runs, the cables between the
amplifier and the speakers should be as short as possible and have good quality.
The AMBIT106 are shipped from factory with the switch in 100V/30W
ATTENTION:
position. If it is connected to a low-impedance amplifier, the speaker will not be
damaged, but will perform way below its full potential. If the speaker is
damaged.
Always respect polarity. All connections are on spring-loaded terminals.

6. PLACEMENT AND MOUNTING

Consider following general rules:
 Place the acoustic enclosures on solid and firm surfaces.
 No obstacles should stand between the enclosures and the audience.
 Although the speakers can be used outdoors, they should not be directly
exposed to sunlight or rain.
 Always adjust the output sound pressure levels to the reproduction
requirements. Despite their small size, they can produce significantly higher
pressure levels than home speakers.
The AMBIT packaging contains everything you need to install the enclosure:
 Two U-shaped metal brackets (liras)
 Allen screws and nuts to fix the liras
 Screws and fixings for walls
 Screws and safety steel sling
 One angled Allen key
8