Front Panel; Rear Panel; Connections And Setting Up - Adastra S260-WIFI User Manual

Introduction
Thank you for choosing the S260-WIFI internet radio streaming amplifier as part of your
background music system. The wireless connectivity of this product brings together online
audio content and smart phone app control for almost unlimited playback possibilities.

Front panel

Rear panel

Connections and Setting Up

Position the S260-WIFI on a stable surface within clear reception of the local WiFi signal and where
controls and connections are accessible.
The unit is powered by the supplied in-line 24Vdc power adaptor. With the power switched off, connect
the DC jack of the power adaptor to the rear panel power inlet (11) and connect the mains lead to the
fig.8 socket of the in-line adaptor with the mains plug connected to a suitable mains outlet.
Supplied with the amplifier are 2 antennas. Both of these need to be connected to the SMA sockets on
the rear of the amplifier, labelled "WIFI ANT" and "BT ANT" (6, 10) to enable clear reception of WIFI and
Bluetooth signals.
The S260-WIFI amplifier can also play mp3 tracks stored onto a USB pen drive or microSD (TF) card.
These should be inserted into the relevant USB port or microSD slot on the front panel (1, 2)
If an external playback device is to be used, connect this to the L+R LINE IN RCA sockets on the rear
panel (7).
1 USB Port
2 microSD card slot
3 Media player controls
4 Media player display
5 Power switch
6 WiFi antenna socket
7 AUX IN (L+R RCA)
8 Left Speaker output
9 Right Speaker output
10 Bluetooth antenna socket
11 24Vdc power inlet DC jack
103.126UK User Manual