Related Manuals for Adastra RM1202
Summary of Contents for Adastra RM1202
- Page 1 RM1202 Rackmount 2-zone Mixer-Amplifier Item ref: 953.162UK User Manual Version 2.0 Caution: Please read this manual carefully before operating Damage caused by misuse is not covered by the warranty...
-
Page 2: Safety Symbol And Message Conventions
Introduction Thank you for choosing the Adastra RM1202 rackmount 2-zone mixer-amplifier as part of your public address system. This unit is designed to offer high quality, dependable service for mobile and installed systems. Please read this manual to gain the best results from your product and avoid damage through misuse. -
Page 3: Front Panel
Front panel Media player SD card slot Mic 1 level control USB port Mic/Line 2 level control Mic 1 zone assign buttons Mic/Line 3 level control Mic/Line 2 zone assign buttons Line 4 level control Mic/Line 3 zone assign buttons Line 5 / Media Player level control Line 4 zone assign buttons Zone 1: Bass EQ... -
Page 4: Dip Switches
This is useful for installed systems where the complete music mix needs to go to every speaker. The RM1202 can also be used as a stereo 100V amplifier by connecting a Left line input to Line 4 enabled to Zone 1 and Right line input to Line 5 enabled to Zone2. -
Page 5: Speaker Outputs
Speaker outputs The RM1202 has a separate speaker output for each zone (27, 28) connected via a single terminal block. The block is removable to enable easy access to the screw terminals. Each zone output can be used to power either 100V line speakers or standard 4Ω or 8Ω speakers. -
Page 6: Operation
Operation When all connections to the amplifier are made, turn all rotary controls down and switch on the power (11). The power LED will illuminate. To check for correct operation of the system, select an input source and output zone for testing. In the following example, Mic.1 input and Zone 1 output have been selected. - Page 7 (ensure that the RM amp is powered on and within reception range) 3. Select “adastra 0000” and the sending device should confirm that it is connected as an audio device. (note that “0000” may be a different number if it has been edited – see below) 4.
-
Page 8: Specifications
Specifications Power supply 110-230Vac, 50/60Hz (IEC) Output power 2 x 120Wrms Audio source USB/SD/FM/BT audio player Bluetooth version Inputs 1 x mic (XLR), 2 x mic/line (6.3mm jack), 2 x line (twin RCA) Input impedance 1kΩ (mic/line) Input sensitivity -11dB (line), -46dB (mic) Zone outputs: line 2 x RCA Zone outputs: speaker...