Introduction: Thank you for choosing this Adastra 1U-series amplifier This product has been designed to offer reliable, high quality mixing for stage and/or studio applications with unfailing consistency. In order to gain the best results from this equipment and avoid damage through misuse, please read and follow these instructions and retain for future reference.
MIC1 + MIC 2 – 2 x balanced 6.3mm jack MIC inputs Connection The Adastra A1U-series mixer-amps and S1-series slave can drive EITHER 100V line OR 4-16Ω speakers. Both types of speaker should NOT be connected together to the same amplifier.
Page 4
Low Impedance Speakers If standard low impedance (4Ω, 8Ω or 16Ω) speakers are being used, these should be connected to the 6.3mm output sockets on the rear panel using quality speaker jack leads. Both of these outputs are fed from the same amplifier section, which is mono.
For MIC channels priority, increasing the VOX control will cause the level of playback through the LINE or USB/SD/FM channels will be reduced when speaking into MIC1 or MIC2. Adjust this control to achieve the required amount of “ducking” of the other channels when MIC channels are used. SPECIFICATIONS Model A121U A251U S121 S251 Power supply Switchable 110/240Vac, 50/60Hz (IEC) Output: RMS @ 4Ω...