BMW M4 COUPE Owner's Manual page 143

Sequential mode D/S
Principle
In sequential mode, it is possible to shift gears
manually using the selector lever or the shift pad‐
dles without letting off the gas.
General information
Shortly before falling below a gear-dependent
minimum speed, the transmission is automati‐
cally downshifted.
Once the maximum engine speed is attained,
upshifting is not automatically performed in se‐
quential mode and the kickdown is deactivated.
It is also possible to start out in 2nd gear; for in‐
stance, on icy roads.
Activating sequential mode
Push the selector lever out of Drive mode in the
D/S direction, arrow 1, or shift via the selector
lever, arrows at 2.
Sequential mode is activated. The engaged gear
is displayed in the instrument cluster, e.g., 1.
Deactivating sequential mode
Push the selector lever out of the center position
in the D/S direction. Drive mode is activated.
The engaged gear is displayed in the instrument
cluster along with a D, e.g., 1 D.
Online Edition for Part no. 01405A38097 - VI/21
Driving
Gear change
Principle
Manual gear-shifting is possible via the shift pad‐
dles or the selector lever in sequential mode.
The shift paddles on the steering wheel allow
you to shift gears quickly while keeping both
hands on the steering wheel.
General information
Shifting
Gears will only be shifted at appropriate engine
and road speeds; for instance, downshifting is
not possible if the engine speed is too high.
The lowest possible gear is selected by simulta‐
neously operating the kickdown and moving the
selector lever forward or actuating the left shift
paddle.
Temporary sequential mode
After a shift paddle is actuated in Drive mode, the
system temporarily switches to sequential mode.
After conservative driving in sequential mode
without acceleration or shifting via the shift pad‐
dles for a certain amount of time, the transmis‐
sion switches back to Drive mode.
Permanent sequential mode
Sequential mode remains permanently active if it
was active before the shift paddle was actuated.
Switching to Drive mode
It is possible to switch to Drive mode as follows:
pull and hold the right shift paddle.
Switching via the selector lever
▷ To shift up: pull the selector lever rearwards.
▷ To shift down: press the selector lever for‐
ward.
A shift in Drive mode causes a switch to Sequen‐
tial mode.
CONTROLS
143