Table of Contents
Advertisement
12. INSTALLATION OF FRONT FEEDER AND REAR REWINDER
OPTIONS
NOTE: Below options are to be installed by an authorized
RS reseller.
Installation of the Front Feeder Option (Includes 2 brackets, one spindle, and
mounting hardware).
1. Install the Front Feeder to the inside of the front frames using four 1/4" (M6)
hexagon bolts on each side (Figure 1).
Installing the Rear Rewinder Option (Includes motorized winder, bracket, one
spindle, and mounting hardware).
1. Remove the left and right covers by using a screwdriver (four screws on
each side cover) (Figure 2 & 3).
2. Remove the lever knob screw and lever (Figure 4).
3. Remove the rear cover by removing all
12 screws (4 top, 4 bottom, and 2 on
each side) (Figure 5 & 6).
4. Disassemble the power switch bracket and place the left rewinder outside
of the frame; fasten with round head 3/16"(M5) screws (included in the
option kit). Then, reinstall the power switch bracket (Figure 7).
5. Install the right rewinder on the outside of the frame and connect the motor
wire connector to the rear wire
(Figure 8 & 9).
6. Reinstall the rear cover.
7. Reinstall the side covers.
8. Reinstall the lever knob and screw.
Figure 5
Figure 8
13
Figure 1
Figure 2
Figure 3
Figure 4
Figure 6
Figure 7
Figure 9
Advertisement
Table of Contents
